Step 1:
Ensure the area to be repaired is clean, dry, and free of grease. Remove any loose or protruding particles if necessary.
Ensure the area to be repaired is clean, dry, and free of grease. Remove any loose or protruding particles if necessary.
Step 3:
Select multiple shades of Hard Wax PLUS and a transparent HWP stick to match the surface. Hold the Hard Wax PLUS sticks alternately to the hot tip of the Gas Heating Iron. Then allow the colour mixture to flow in the direction of the grain.
Select multiple shades of Hard Wax PLUS and a transparent HWP stick to match the surface. Hold the Hard Wax PLUS sticks alternately to the hot tip of the Gas Heating Iron. Then allow the colour mixture to flow in the direction of the grain.
Step 4:
Remove excess wax with the Special Fillers Applicator (sharp grooves for surfaces, rounded grooves for edges).
Remove excess wax with the Special Fillers Applicator (sharp grooves for surfaces, rounded grooves for edges).
Step 5:
Apply a darker shade of Hard Wax PLUS to match the grain. Draw the hot tip of the Gas Heating Iron over the filled area in short strokes in the direction of the grain. The remove the excess wax with the Special Fillers Applicator. Use the sharp grooves for the surface and the rounded grooves for edges.
Apply a darker shade of Hard Wax PLUS to match the grain. Draw the hot tip of the Gas Heating Iron over the filled area in short strokes in the direction of the grain. The remove the excess wax with the Special Fillers Applicator. Use the sharp grooves for the surface and the rounded grooves for edges.
Step 6:
Clean/degrease the surface using the Sanding Pad, “coarse”.
Clean/degrease the surface using the Sanding Pad, “coarse”.
Step 7:
Seal with Special Repair Lacquer PLUS, spraying in a fine mist from 30-40 cm. Avoid avoiding over-application.
Seal with Special Repair Lacquer PLUS, spraying in a fine mist from 30-40 cm. Avoid avoiding over-application.
Before
After
