Step 1:
Ensure the area to be repaired is clean, dry, and free of grease. Remove any loose or protruding particles if necessary.
Ensure the area to be repaired is clean, dry, and free of grease. Remove any loose or protruding particles if necessary.
Step 2:
Use the Red Marten Brush and Colour Touch-Up to tint the damage to match the surrounding area.
Use the Red Marten Brush and Colour Touch-Up to tint the damage to match the surrounding area.
Step 3:
Select several colour shades to match the surface (light/medium/dark). Hold the Hard Wax sticks alternately to the hot tip of the Gas Heating Iron. Then allow the colour mixture to flow in the direction of the grain.
Select several colour shades to match the surface (light/medium/dark). Hold the Hard Wax sticks alternately to the hot tip of the Gas Heating Iron. Then allow the colour mixture to flow in the direction of the grain.
Step 4:
Use the Special Filler Applicator to remove excess wax. Use the sharp grooves for the surface and the rounded grooves for edges.
Use the Special Filler Applicator to remove excess wax. Use the sharp grooves for the surface and the rounded grooves for edges.
Step 5:
Restore texture using the Special Scraper and Colour Touch-Up as needed.
Restore texture using the Special Scraper and Colour Touch-Up as needed.
Step 6:
Seal with Sprüh-König Special Repair Lacquer PLUS, misting from 30-40 cm. Adjust gloss level if necessary.
Seal with Sprüh-König Special Repair Lacquer PLUS, misting from 30-40 cm. Adjust gloss level if necessary.
Step 7:
Finish with the Sanding and Polishing Cloth (green side for polishing, white side for matting).
Finish with the Sanding and Polishing Cloth (green side for polishing, white side for matting).
Before
After
